Trimble GCS900 GPS Machine Control
- Make sure you have the Trimble equipment
- Machine Display - Trimble CB430 or CB460
- Receivers - Trimble MS990 , MS992, or MS995 Antennas
- Two coil cables
- Set the two antenna receivers (MS990 / MS992 / MS995) on top of the masts - make sure to completely tighten the brackets
- Plug in the coil cables to the machine and the receivers
- Hook up the CB430 or CB460 display to the bracket in the cab and plug it in
- Make sure the machine is on, then power the CB430 or CB406 display - it will take a minute to power up
- Once the display is powered select the menu button
- Scroll down to Restore settings, select OK
- Highlight Machine Settings, select OK
- Highlight the machine you are on, Select OK
- If any messages appear, select OK
- Select Back
- Scroll up to Select Design, Select OK
- Highlight the current Project your on with the most current date, select OK
- At the top it should say Select Design: Your job name
- Select Back
- The job should be shown along with your machine on it.
- Using the Scroll button , scroll until the Northing, Easting, and Elevation page shows up
- Verify with the Trimble rover that the tips are accurate within 0.15 ft
- Switch between tips by selecting the button next to the blade tip symbol
- If its within that accuracy then scroll to the page desired using this button
- Do a 20’ pass in autos and make sure you are accurate within a 0.10 ft
- Once that checks out you are ready to push dirt
We sell Trimble machine control - check out what we have available - https://www.4kequipment.com/trimble-machine-control/